After starting win stop scaining plz help me experts.

[mianrashid]

kae dafa ayesa hota hai k sys chaltay ho light of ho jate hai aur jab ham is ko dobra starta kartay hain to start main win hard dirve ke scaning start karte hai SCAINING DISK DRIVE C PHR D AUR PHR E ...
MAIN CHAHTA HOUN K AGAR LITE OFF JO JAYE TO DOBARA PC START KARON TO WINDOW HARD DRIVES KE SCANING NA KARY KIA IS KA KOE HAL HAI PLZ EXPERTS HELP ME .
RASHID

[!~*DON*~!]

Rashid bhai aapki scanning hoti hai magar mera pc aesa karta hai ky agar light chli jaye tu mein pc On karon tu scanning run nahi hoti
Experts mein chahta honn meri scanning ho agar achanak light janey sy PC off ho jaye help kijye please

or yeh bi bataye yeh kis wajha sy scanning nahi karta

kis Masla Hai

[Sharp]

GO>
HKEY_LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\CONTRO L\Session Manager
The default value is for BootExecute is autocheck autochk *. When you use the /x switch, it will add a /k parameter prior to the asterisk. The /k parameter excludes volumes from being checked for the presence of a dirty bit.
For example, I run the command chkntfs /x c: in command prompt. This command would modify this registry entry to autocheck autochk /k:c *

[mianrashid]

Khizar Bahi Acha Hai Na K Scaning Nahe Karta Time Save Karnay Ka

[Fahad_997]

Sub se pehly aap apni Drives ko NTFS main Convert krain

open a dos prompt and give the command
convert d: /fs:ntfs
this command would convert your d: drive to ntfs.
if the system cannot lock the drive, you will be prompted to convert it during next reboot.
Normally you should select yes.
Conversion from fat/fat32 to ntfs is non-destructive, your data on the drive will NOT be lost.
Be aware that converting to ntfs will make that partition of your
drive unreadable under dos unless you have ntfs utilites to do so.

Aur phir har drive k saath yeh krain

[!~*DON*~!]

Fahad Bhai problem ka bi koi hal bataye

[mianrashid]

sharp baiya koe samj nahe aye kia karna hai

aur fahad bayia ntfs k bina change kiya koe hal nahe hai kia

[Sharp]

Boot Exicute mean autocheck autochk * << ye value likhi hogi..
usy change ker k autocheck autochk /k:c * << ye rekh deen...
or PC restart ker deen...

[Fahad_997]

sharp baiya koe samj nahe aye kia karna hai

aur fahad bayia ntfs k bina change kiya koe hal nahe hai kia

Bhai aap aik Dafa Mere tariqe se Check Disk kr lo Phir Computer k On hone se pehly windows Disks ki Checking nahin kre gi....
Aap ki partition agar Fat32/Fat main hai to try kr lo waisy main ne NTFS main check kia tha....

[!~*DON*~!]

OK Thanks