Diskette 0 Seek Failure

**decent_soldiers** · 1st August 2009, 09:09 AM

Asslam_O_Alikum ..

Respectable Members, ap logo say ek choty say maslay ka hal darkar hai,

hoa khuch youn k maine apni 4 hard disks (10GB, 20GB, 40GB & 80GB) apny computers say nikal k rakhi thi. jub maine nika k rakhi thi to ye bilkul running halat main thi aur in main kisi main khuch b problem nahi tha...

aub jub b mian in main say koi hard disk CPU main lagta hoon to black screen pe ek error aa raha hai

DISKETTE 0 SEEK FAILURE

main her tarah say jumber setting kar k dekh chuka hoon, Hard disk ke cable b new lay k dekh le maine, but masla youn ka youn. jub maine in hard disks ko ek running CPU pe slave bana k use karna chaha to ye error aaya

DISKETTE 1 SEEK FAILURE

Please meri help karain.......

Ap sub ka advance main shukriya

**Zaara** · 1st August 2009, 09:32 AM

Check your hardware configuration in your computer. How many hard drives do you have? on your IDE Cable, the big skinny Grey cord, make sure you plug the end cord of the IDE cable to your hard drive and your CD/DVD ROM drive to your middle one and the other end to your motherboards primary IDE port(Should say on your motherboard were to plug into Primary IDE) and change your jumpers on your CD/DVD Rom to slave(Look on the drive it should say were to plug it in for the jumpers) and your hard drive you use to store your OS on to Master,|| and your other hard drive you use to store your photos and all on master also(plug this on the secondary IDE port if there isn't one, refer to step 1) and start up your computer(but remember if you have a second hard drive, use the end of the ribbon cable to your hard drive and the other to the motherboard(usually the blue part that goes into the motherboard) and it should work. if it don't tell me your hard drive configuration and i shall help you. and i think that error message shows if these steps didn't help, go into your bios and change the settings on the drives to

1:Primary Master Drive Boot Device - CD/DVD Rom
2: Primary Slave drive - hard drive
3: Secondary Master Drive - Hard drive.

if these don't work refer to this post and i will try and help you on your problem, but post your hard drive configuration and maybe some pictures of your bios so i can help properly.

**Zaara** · 1st August 2009, 09:34 AM

for dell users u have change your first boot hardware to Harddisk and the go to integrated components and disable FDC.

**Thinkme1st** · 1st August 2009, 09:47 AM

Bios ko defult per rekhny nehi tu..system me cell nikal ker again lagoo then detect kero

**XoOaiL** · 1st August 2009, 01:15 PM

urdu ya roman urdu use kia kren

**ashfaq1** · 6th March 2011, 01:42 AM

bios ma setting ka masla ha....... bios ma ja kr advanced setting ma 1 boot 2 boot 3 boot ki setting karo 1 boot ma attapi cd room phir hdd and fdd phir flopy kay option ko disable kr lo phir windows save karo partition kar kay dobara........