System Restart Problem

[aruba195]

Asslam o Alaikum

Friends muje aik problem a rhe hai wo ye hai k mera system restart ho jata hai khud ba khud

Naye window b ki hai but problem solve nai hui


Thanks & Regards

[Zohaib hyder]

Bhai light ka prob h jhatke maarti hogi ya phr powr supply ko check karwaen aur bhai khud ba khud restart hone ki kai wajoohat hoti hain kabhi kabhi hrd disk ki b prob hojati h to us sy b ye hota h.

[waqasalisha]

reboot your pc or f8 press krte raho pir wha pe disable auto restart pe enter kr do .. pir computer restart ni ho ga agr hardware main koi issue hova to blue screen aye gi. ager esa hota hai to is ka b elaaj ho jye ga.

[Sahil_Jaan]

system me virus he avast se scan kare phir system set ho jay ga

[aruba195]

Auto Restart Dissable krne per blue screen a jati hai

[waqasalisha]

Auto Restart Dissable krne per blue screen a jati hai

its mean ap ki Ram/hard disk main koi issue hai.

1. ap k system main kitni rams lagi hoi hai ???

[coolcool1227]

Check

1) Power supply voltages
2) CPU Heating up or not
3) Conducting paste on Processor
4) Cables and Wiring (Data Cables, Power Cables etc)
5) Cell on Motherboard
6) Jumpers on Motherboard and Media Drives (Optical and Storage for Master, Slave Configuration)
7) In case of more than one RAMs, match their Bus speed in MHz. i.e. all RAMs must have same Bus speed.
8) RAM compatibility with Mother Board.
9) Any burn or blown or leaked component (IC, Capacitor, Resistor etc) on Mother Board, External or Internal Cards, RAM etc.

Clean

1) All Fans including Processor fan
2) Processor Heat Sink
3) RAM, External Cards (VGA, LAN, modem etc)
4) All Slots (DIMM, Processor, PCI and PCI-E etc)
5) Power Supply Unit
6) Motherboard
7) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-E slots.

Scan and Repair

1) Bad Sectors, System Files on HDD (by chkdsk or third party softwares)
2) For viruses on HDD

Reseat

1) Processor
2) RAM
3) Cell on Motherboard
4) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-e slots.

Reset

1) BIOS
2) Jumper Setting on Motherboard

Shuffle

1) RAM in slots
2) Media Drives (Optical and Storage)
3) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-e slots.

Check the Sounds/Beeps

1) Check beep and its count with and without RAM.
2) Sound from the fans mounted on processor, VGA, Power Supply and CPU etc.

Wash

Motherboard, External or Internal Cards, RAM etc. with petrol or water and dry with blower.

or read this thread

http://www.itdunya.com/t323680/

[aruba195]

Ok check krta hu

Thanks

[raheelraza77]

reset bios or change power supply or reason is heatup

[Ihsasdaudzai]

Behn RAMs nikal ky wapas lagao tek ho jayega InshALLAH

[JohnnyG]

Ek dafa processor, RAM etc sab nikaal kar dobara lagao.

agar 2 RAMS hain to pahle ek lagao...and check karo...
phir doosri lagao.. Uper ek bhai ne bara lamba comment kiya hai..woh zaroor dekho...

[zainjawaid11]

Check

1) Power supply voltages
2) CPU Heating up or not
3) Conducting paste on Processor
4) Cables and Wiring (Data Cables, Power Cables etc)
5) Cell on Motherboard
6) Jumpers on Motherboard and Media Drives (Optical and Storage for Master, Slave Configuration)
7) In case of more than one RAMs, match their Bus speed in MHz. i.e. all RAMs must have same Bus speed.
8) RAM compatibility with Mother Board.
9) Any burn or blown or leaked component (IC, Capacitor, Resistor etc) on Mother Board, External or Internal Cards, RAM etc.

Clean

1) All Fans including Processor fan
2) Processor Heat Sink
3) RAM, External Cards (VGA, LAN, modem etc)
4) All Slots (DIMM, Processor, PCI and PCI-E etc)
5) Power Supply Unit
6) Motherboard
7) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-E slots.

Scan and Repair

1) Bad Sectors, System Files on HDD (by chkdsk or third party softwares)
2) For viruses on HDD

Reseat

1) Processor
2) RAM
3) Cell on Motherboard
4) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-e slots.

Reset

1) BIOS
2) Jumper Setting on Motherboard

Shuffle

1) RAM in slots
2) Media Drives (Optical and Storage)
3) Any External Card (Graphic, LAN or Modem etc) installed on PCI or PCI-e slots.

Check the Sounds/Beeps

1) Check beep and its count with and without RAM.
2) Sound from the fans mounted on processor, VGA, Power Supply and CPU etc.

Wash

Motherboard, External or Internal Cards, RAM etc. with petrol or water and dry with blower.

or read this thread

http://www.itdunya.com/t323680/

Very nice