Results 1 to 2 of 2

Thread: System Voltage/Low Battery

  1. #1
    ashfaq baloch's Avatar
    ashfaq baloch is offline Junior Member
    Last Online
    6th May 2017 @ 11:46 AM
    Join Date
    17 Mar 2010
    Location
    KARACHI
    Posts
    27
    Threads
    11
    Credits
    1,022
    Thanked: 1

    Default System Voltage/Low Battery

    Mere system main system voltage/low battert ka error start hone se pehle aata hai . can anybody give me a solution of this problem.

  2. #2
    KHANZZzzz's Avatar
    KHANZZzzz is offline Senior Member+
    Last Online
    23rd December 2014 @ 10:39 PM
    Join Date
    14 Dec 2008
    Location
    Athens, Greece
    Age
    34
    Gender
    Male
    Posts
    2,652
    Threads
    187
    Credits
    127
    Thanked
    446

    Default

    Assalam O ALikum,

    Use this way:

    1) Clear NVRAM

    2) Reset system set up options

    3) Clear System Event Log in BIOS Screen

    These did not resolve the problem the next step did

    4) Record the System Setup Settings

    5) Remove the Battery and reinstall it

    The battery must have been lose because reinstalling it appears to have cleared the problem at the moment

    .........

    Generally replace the CMOS BATTERY...........

    CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information Guide.


    A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.

    If you have to repeatedly reset time and date information after turning on the computer, replace the battery.

    CAUTION: A new battery can explode if it is incorrectly installed. Replace the 3-V CR2032 battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

    Record all the screens in the system setup program so that you can restore the correct settings.

    Remove the computer cover.

    Locate the battery socket.

    Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.

    NOTICE: To avoid damage to the system board while you pry the battery loose, be sure to insert the plastic screwdriver between the battery and the socket (not the system board).



    Insert the new battery into the socket with the side labeled "+" facing up and snap the battery into place.

    NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

    Replace the computer cover.

    Connect your computer and devices to electrical outlets, and turn them on.

    Access the system setup program and restore the settings you recorded in step 1.

    Properly dispose of the old battery. See the safety instructions in your Owner's Manual or Product Information Guide.

Similar Threads

  1. Alert System battery voltage is low
    By husnews in forum Ask an Expert
    Replies: 0
    Last Post: 12th March 2014, 09:27 PM
  2. System battery
    By moon jii in forum Ask an Expert
    Replies: 6
    Last Post: 20th July 2013, 02:22 PM
  3. system battery voltage
    By shahzad umar in forum Ask an Expert
    Replies: 2
    Last Post: 28th March 2013, 12:48 AM
  4. Lcd voltage and monitor voltage
    By ariyanp480782 in forum Ask an Expert
    Replies: 3
    Last Post: 25th October 2012, 03:58 AM
  5. System battery voltage is low :(
    By Mawara in forum Ask an Expert
    Replies: 19
    Last Post: 19th March 2012, 11:59 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •