How to remove write protected error using cmd

[Arslan.Ahmad]

Removing write-protection using Diskpart

With your USB drive plugged in, launch a command prompt. Do this by searching for cmd.exe in the Start menu (or Start screen in Windows 8). In Windows XP, click Start then Run, and type cmd.exe in the box.

NOTE: you may need to run Cmd.exe with administrator privileges if you see an “access is denied” message.

To do that, right-click on the shortcut and choose Run as administrator. In Windows 8, simply choose Command prompt (admin).

Now, type the following, pressing Enter after each command:

diskpart

list disk

select disk x (where x is the number of your USB flash drive – use the capacity to work out which one it is)

attributes disk clear readonly

clean

create partition primary

format fs=fat32 (you can swap fat32 for ntfs if you only need to use the drive with Windows computers)

exit

[Amjadale]

Dear Great Work

[Sameer78]

نائس شیئرنگ
ہمارے ساتھ ٹیوٹوریئل شیئرکرنےکاشکریہ
مزید شیئرنگ کا انتظار رہے گا۔

[Muaavia]

عمدہ شیئرنگ

[Arslan.Ahmad]

All friend ka pasand karne ka shukria

[saqib_bindass]

Try Karenge....

[Asfand4U]

thanks dear

[faheemsandhu]

not working

[silvercloud]

bht khoob...

[MindMergePk]

good work, thanks

[Sanaullah Me]

Bahout Ache.

[Reloadedpc]

NO Ya HAR keSAM KE usb OR MEMORY card PAR WORK NAE kRTa

ITS TOTaly CRAp